Addictive-desert-designs 2010 - 2014 Ford Raptor Fender Inner User Manual download pdf

–

1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the

emergency brake set.

2. You will need the following tools:

a. 1/8" drill bit

b. 3/16" drill bit

c. Grinder

d. Cut off Wheel for grinder

e. Power Drill

f. Phillips head Bit attachment

g. Rivet gun for 3/16" rivets

h. 10mm socket

i. 8mm socket

j. 5.5mm socket

k. Ratchet

3. Hardware Included:

a. 3 - Mounting Tabs (1 each Small, Medium and Large)

b. 10 - Self Tapping Screws

c. 12 - 3/16" Rivets

d. 12 - fender washers

1. Remove factory Front Fenders and Fender Inners.

2. Mark front valance for trimming ( 1.75"

on top and 3.00" on bottom) and cut as

in image at right.

1 2 3 4

Page 1

– 1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the emergency brake set. 2. You will need the followin

Page 2

3. Measure and Cut away pinch welds at the rear of the wheels. Start at 6.75" down from mount, see picture below right, and cut down to the

Page 3

6. Find the three mounting tabs, starting from the large tab put into position and drill a 1/8" hole. Use the self tapping screw to attach to

Page 4

8. Now that fit is verified, remove the Fender Inners and have the inside covered with bedliner material (i.e. Line-x, rhinoliner or equivalent).

No comments

Addictive-desert-designs 2010 - 2014 Ford Raptor Fender Inner User Manual